Addonics Technologies ZSAUSCSF User Manual

Enclosure Overview

Screw 2

Switch

Screw 1

Addonics

T E C H N O L O G I E S

Fan

USIB Port

Power

Connector

Zebra USIB SATA Drive Enclosure

ZSAUSCSU & ZSAUSCSF

Removing the front panel

You can remove the front panel of the enclosure

to access the drive drawer of the optical drive.

User’s Guide

Step 1

Loosen the two screws from the rear panel. Pull out the interior tray from the

enclosure.

Step 2

Connect the 15-pin SATA power cable to the power connector of the hard drive.

Also connect the 7-pin SATA data cable to SATA port of the hard drive.

FCC Warning Statement

This equipment has been tested and found to comply with the limits for a class B digital

device pursuant to Part 15 of the FCC rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy. If not installed and

used in accordance with the instructions, it may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If the equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment on and off, the user

is encouraged to try and correct the interference by one or more of the following

suggestions.

15-pin SATA

power cable

Reorient or relocate the receiving antenna

Increase the distance between the equipment and the receiver

Connect the equipment to a different power outlet other than the one where receiver is

connected

7-pin SATA

data cable

Consult a certified television or radio technician